Load data for 5.6 x 50 R Mag. + .224 | 50gr | Remington HP Power-Lokt

Recommended Powder(s): Alliant AR-Comp, Alliant Reloder-10x, IMR 4198, Norma 200, Vihtavuori N130

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.224 \| 50gr \| Remington HP Power-Lokt
Bullet Weight:	50gr \| 3.2g
Bullet Diameter:	0.224" \| 5.69mm
Bullet Length:	1.000" \| 25.4mm
Caliber:	5.6 x 50 R Mag. load data
Case Length (l3):	1.968" \| 50.0mm
Cartridge Length (C.O.L.):	2.365" \| 60.1mm
Seated Depth:	0.603" \| 15.3mm
Shank Seated Depth:	0.603" \| 15.3mm
Case Capacity:	34.0 Grains of Water \| 2.21 cm³
Primer Size:	Small Rifle (SR)
Max. allowed Pressure:	49313 psi \| 3400 bar
LID:	LID_B5127_C915
Last updated:	2025-01-01

Load data for 74 loads in caliber 5.6 x 50 R Mag. with .224 | 50gr | Remington HP Power-Lokt bullet and 37 powders such as Alliant AR-Comp, Alliant Reloder-10x, IMR 4198, Norma 200, Vihtavuori N130. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AR 2207	<<locked>>	88%	44295	90%	**73	100%
ADI AR 2219	<<locked>>	90%	43685	89%	**89	96%
Accurate 2015	<<locked>>	96%	44034	89%	**66	98%
[Accurate 2460]*	<<locked>>	93%	42728	87%	**23	93%
Accurate 2495	<<locked>>	96%	34664	70%	**48	96%
[Accurate 2520]*	<<locked>>	97%	39552	80%	**17	93%
Alliant AR-Comp 👍	<<locked>>	96%	38189	77%	**30	99%
Alliant Reloder-10x 👍	<<locked>>	93%	43134	87%	**79	99%
Alliant Reloder-7	<<locked>>	86%	43627	88%	**17	99%
Baschieri & Pellagri 106	<<locked>>	90%	44324	90%	**77	97%
[Hodgdon Benchmark]*	<<locked>>	95%	44164	90%	**04	92%
[Hodgdon CFE BLK]*	<<locked>>	86%	43569	88%	**45	91%
Hodgdon H322	<<locked>>	96%	43685	89%	**89	96%
Hodgdon H335	<<locked>>	91%	44092	89%	**92	95%
Hodgdon H4198	<<locked>>	87%	43511	88%	**77	96%
Hodgdon TrailBoss	<<locked>>	96%	29414	60%	**28	100%
[IMR 3031]*	<<locked>>	97%	33707	68%	**95	93%
IMR 4198 👍	<<locked>>	92%	44353	90%	**59	99%
[Lovex D073.4]*	<<locked>>	92%	43047	87%	**10	92%
[Lovex D073.5]*	<<locked>>	94%	43453	88%	**43	93%
Norma 200 👍	<<locked>>	89%	43134	87%	**56	99%
[Norma 202]*	<<locked>>	97%	38130	77%	**61	93%
ReloadSwiss RS 14	<<locked>>	96%	29066	59%	**70	100%
[ReloadSwiss RS 40]*	<<locked>>	94%	44280	90%	**59	94%
[Rottweil R 901]*	<<locked>>	96%	41539	84%	**04	94%
SNPE Vectan BA6 1/2	<<locked>>	85%	44251	90%	**17	100%
SNPE Vectan SP 10	<<locked>>	90%	43816	89%	**79	95%
[SNPE Vectan Tubal 3000]*	<<locked>>	96%	41046	83%	**25	94%
[SNPE Vectan Tubal 5000]*	<<locked>>	96%	32880	67%	**28	92%
[Somchem S321]*	<<locked>>	96%	44251	90%	**76	92%
Somchem S335	<<locked>>	96%	39247	80%	**15	95%
Vihtavuori N120	<<locked>>	89%	43105	87%	**04	100%
Vihtavuori N130 👍	<<locked>>	95%	44077	89%	**27	99%
Vihtavuori N133	<<locked>>	97%	37797	77%	**89	96%
[Vihtavuori N140]*	<<locked>>	97%	36071	73%	**69	93%
[Vihtavuori N540]*	<<locked>>	96%	35302	72%	**76	92%
[Winchester 748]*	<<locked>>	96%	43395	88%	**79	92%

Max Load - Barrel Length: 23.60''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AR 2207	<<locked>>	81%	36085	73%	**05	100%
[ADI AR 2219]*	<<locked>>	81%	31879	65%	**90	91%
[Accurate 2015]*	<<locked>>	81%	26934	55%	**36	92%
[Accurate 2460]*	<<locked>>	89%	36361	74%	**79	90%
[Accurate 2495]*	<<locked>>	86%	24627	50%	**49	90%
[Accurate 2520]*	<<locked>>	94%	34693	70%	**89	90%
[Alliant AR-Comp]*	<<locked>>	81%	23815	48%	**64	92%
Alliant Reloder-10x	<<locked>>	81%	29762	60%	**44	95%
Alliant Reloder-7	<<locked>>	81%	37333	76%	**82	98%
[Baschieri & Pellagri 106]*	<<locked>>	81%	33083	67%	**15	93%
[Hodgdon Benchmark]*	<<locked>>	90%	37898	77%	**59	90%
[Hodgdon CFE BLK]*	<<locked>>	83%	40277	82%	**72	90%
[Hodgdon H322]*	<<locked>>	85%	30821	63%	**54	91%
[Hodgdon H335]*	<<locked>>	82%	32430	66%	**97	90%
[Hodgdon H4198]*	<<locked>>	81%	35795	73%	**90	93%
Hodgdon TrailBoss	<<locked>>	82%	23540	48%	**77	100%
[IMR 3031]*	<<locked>>	91%	28979	59%	**51	90%
IMR 4198	<<locked>>	81%	32285	65%	**64	97%
[Lovex D073.4]*	<<locked>>	88%	36680	74%	**72	90%
[Lovex D073.5]*	<<locked>>	90%	37014	75%	**92	90%
Norma 200	<<locked>>	81%	34069	69%	**46	97%
[Norma 202]*	<<locked>>	92%	32445	66%	**07	90%
ReloadSwiss RS 14	<<locked>>	82%	23380	47%	**19	100%
[ReloadSwiss RS 40]*	<<locked>>	87%	35099	71%	**49	90%
[Rottweil R 901]*	<<locked>>	89%	33025	67%	**94	90%
SNPE Vectan BA6 1/2	<<locked>>	81%	39117	79%	**28	100%
[SNPE Vectan SP 10]*	<<locked>>	81%	32184	65%	**94	90%
[SNPE Vectan Tubal 3000]*	<<locked>>	89%	32184	65%	**05	90%
[SNPE Vectan Tubal 5000]*	<<locked>>	94%	30472	62%	**66	91%
[Somchem S321]*	<<locked>>	92%	39436	80%	**64	90%
[Somchem S335]*	<<locked>>	87%	30081	61%	**72	91%
Vihtavuori N120	<<locked>>	81%	33808	69%	**00	100%
[Vihtavuori N130]*	<<locked>>	81%	28427	58%	**36	94%
[Vihtavuori N133]*	<<locked>>	85%	26556	54%	**67	91%
[Vihtavuori N140]*	<<locked>>	93%	32198	65%	**71	91%
[Vihtavuori N540]*	<<locked>>	94%	32692	66%	**00	90%
[Winchester 748]*	<<locked>>	92%	38711	78%	**74	90%

Start Load - Barrel Length: 23.60''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data